Installed Windows 10 on a USB3 SSD drive using this method (cloning an existing Virtualbox VM).
The OS run quite good after boot, mouse and keyboard (USB) works, my printer is recognized.
My main goal is to boot on this external drive to flash ROM on some Samsung phones.
I goes to Intel page, downloaded, installed, rebooted PROWinx64.exe, but still no ethernet card recognized.
And even if I can see some USB devices, my Samsung phone (SM_J500FN) is not recognized in Odin3_v3.14.1. Downloaded, installed, rebooted Samsung USB drivers
I try to figure out how to be able to use network card and USB device.
Any clue please ? (I’m not a Windows guy, I use Linux since > 15 years).
From my Linux box :
lshw
:
description: Ethernet interface
product: Ethernet Connection (2) I219-V
vendor: Intel Corporation
lspci -v
:
00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (2) I219-V (rev 31)
Subsystem: ASUSTeK Computer Inc. Ethernet Connection (2) I219-V
Flags: bus master, fast devsel, latency 0, IRQ 121
Memory at f7000000 (32-bit, non-prefetchable) [size=128K]
Capabilities: [c8] Power Management version 3
Capabilities: [d0] MSI: Enable+ Count=1/1 Maskable- 64bit+
Capabilities: [e0] PCI Advanced Features
Kernel driver in use: e1000e
Kernel modules: e1000e
lsusb -v
:
Bus 001 Device 010: ID 04e8:685d Samsung Electronics Co., Ltd GT-I9100 Phone [Galaxy S II] (Download mode)
Device Descriptor:
idVendor 0x04e8 Samsung Electronics Co., Ltd
idProduct 0x685d GT-I9100 Phone [Galaxy S II] (Download mode)
iManufacturer 1 Sasmsung