On a Dell Vostro 3470 (Intel 300 Series chipset, Windows 11 Pro), the system M.2 SATA SSD goes to about 100% active time as soon as Windows starts and stays there. The desktop lags the whole time. It does this with apps open and with nothing open.
Task Manager, Performance, Disk 1 (C:):
-
Drive: EVMM2/512GB, SSD (SATA), 477 GB
-
Active time: about 97%
-
Throughput: about 15 MB/s read and 5 MB/s write
-
Average response time: about 7.5 ms
A second SATA SSD on the same controller (ADATA SU650, disks D: and E:) stays near 0–4%. CrystalDiskInfo reports the EVMM2 as Good: 33°C, 0 reallocated sectors, SMART attributes at 100, about 10 TB written. The machine has 32 GB RAM with more than 20 GB free.
Device Manager shows Intel(R) 300 Series Chipset Family SATA AHCI Controller. Driver details show iaStorAC.sys 17.9.6.1019 (Intel Rapid Storage Technology, 2021). The hardware id includes PCIVEN_8086&DEV_A352 and CC_0106, so the controller is already in AHCI mode. The SCSI port driver is iaStorAC. storahci is installed with Start = 0, but StartOverride is 3, so the Microsoft AHCI driver does not load at boot.
These changes did not help:
-
PCI Express Link State Power Management set to Off
-
MSISupportedset to 0 on that Intel controller -
Paging file removed
-
SysMain and Windows Search disabled
-
TRIM already enabled (
DisableDeleteNotify= 0) -
Full Restart instead of Shut down
The System log has no iaStorAC “reset to device” events and no disk retry events.
Why does this one SATA SSD stay at 100% active time when it is only moving a few megabytes per second, and what actually fixes it?